小龟直按TVAU07轻触开关.doc
《小龟直按TVAU07轻触开关.doc》由会员分享,可在线阅读,更多相关《小龟直按TVAU07轻触开关.doc(15页珍藏版)》请在得力文库 - 分享文档赚钱的网站上搜索。
1、【精品文档】如有侵权,请联系网站删除,仅供学习与交流小龟直按TVAU07轻触开关.精品文档.客户名称(Customer): _规 格 承 认 书 SPECIFICATION FOR APPROVALMONTH / DAY / YEAR ISSUED01 / 23 / 07 发行贵公司部品名称: 敝公司部品名称:小龟直按轻触开关 PART NAME SUPPLIERS PART NAME 贵公司部品型号: 敝公司部品型号:TVAU07 PART NUMBER SUPPLIERS PART NUMBER 接受印 兹证明此份材料已经收到。ACKNOWLEDGEMENT WE ACKNOWLEOGE
2、RECEIVING THIS DOCUMENT . MONTH / DAY / YEARDATE: / /GMGRLEADERCHECKEDSIGNED相关规格,规格书 / SPECIFICATIONCHECKED SIGNEDTACT SWITCH SPECIFICATION(轻触开关说明书)1.General specification 基本说明1.1 Scope 范围 This specification covers the requirements for single key switches which have no keytop(TACT SWITCHES:MECHANICA
3、L CONTACT).此规范含盖单推柄和无推柄的轻触开关要求1.2 Operating Temperature Range 使用温度范围 -20 to70(normal humidity, normal press.) 正常湿度,标准压力 1.3 Storage Temperature Range 保存温度范围-30 to80(normal humidity, normal press.) 1.4 Test Conditions 测试条件 Tests and measurements shall be made in the following standard clnditions unle
4、ss otherwise specified: 测试和计量按下列标准条件除非特殊说明 Normal temperature (temperature 5 to 35) 标准温度 Normal humidity (relative humidity 45 to85%) 正常湿气 Normal pressure (pressure 860 to 1060 mbars) 标准压力 In case any question arises from the judgement made, tests shall be conducted in the following conditions: Temp
5、erature (202) 温度 Relative humidity (655%) 相对湿度 Pressure (860 to 1060 mbars) 压力2.APPEARNCE, STYLE, AND DIMENSIONS外形,类型和尺寸2.1 Appearance 外形There shall be no defects that affect the serviceability of the product.外形必须无缺陷才不影响产品适用性2.2 Style and Dimensions类型和尺寸 Shall conform to the assembly drawings.符合装配图3
6、.TYPE OF ACTUATION 动作类型Tactile feedback 轻触返回4.CONTACT ARRANGEMENT 1 poles 1 throws 接触形式 1接点1回路(Details of contact arrangement are given in the assembly drawings.)细接点形式在装配图中5.MAXIMUM RATINGS DC 12 V 50 mA 最大额定值APPDCHKDDSGDPART NO:工 程 部赵 高 杰05.11.10研 發 部吴 公 元05.11.10研 發 部周 成 艮05.11.10DOCUMENT NO:SPECT
7、SZ.DOC1/10ZONESYMBDATE APPDCHKDDSGDTACTING SWITCH SPECIFICATION6.PERFORMANCE性能6.1 Electrical电气Item项目Test Condition测试条件Requirements要求6.1.1.Contact Resistance接触电阻Applying astatic load twice the actuating force to the center of the stem,measurements shall be made with a 1 kHz small-current contact resi
8、stance meter.用两倍的动作力作静负载施加于按钮的中心,并用1千赫小电流接触电阻仪测量100 m ohm max.6.1.2.Insulation Resistance绝缘电阻Measurements shall be made following application of DC100V potintial across terminals and across terminals and frame for one minute.在端子与端子之间,端子与外壳之间施加DC100V,一分钟100 M ohm min.6.1.3.Dielectric witstanding volt
9、age电气耐压AC250V(50Hz or60Hz) shall be applied across terminals and across terminals and frame for one minute. 在端子与端子之间,端子与外壳之间施加AC250V(50HZ-60HZ)There shall be no breakdown.没有击穿6.1.4.Bounce抖动Lightly striking the center of the stem at a rate encountered in normal use (3 to 4 operations per sec.),Bounce
10、 shall be tested at “ON”and “OFF”. 在正常使用中(以每秒3-4次周期)轻轻地在手柄中心加力,在通与断瞬间测试抖动 5 m sec max.APPDCHKDDSGDPART NO:工 程 部赵 高 杰05.11.10研 發 部吴 公 元05.11.10研 發 部周 成 艮05.11.10DOCUMENT NO:SPECTSZ.DOC2/10ZONESYMBDATE APPDCHKDDSGDTACTING SWITCH SPECIFICATION6.2Mechanical机械特性Item项目Test Condition 试验条件Requirements 规 格6.
11、2.1.Actuating Force动作力Placing the switch such that the direction of switch operation is vertical and then gradually increasing the load applied to the center of the stem, the maximum load required for the stem to come to a stop shall be measured.开关的动作方向为垂直放置开关向推柄中心逐渐地增加负荷直到推柄停止时所测量的最大负荷160 30 gf 250
12、 50 gf6.2.2.Travel行程Placing the switch such that the direction of switch operation is vertical and then applying a static load twice the actuating force to the center of the stem,the travel distance for the stem to come to a stop shall be measured. 开关的动作方向为垂直放置开关,并以双倍动作力的静负荷作用推柄中心,测量推柄从开始到停止的行程距离 0.
13、20 0.1mm6.2.3.Return Force返回力The sample switch is installed such that the direction of switch operation is vertical and,upon depression of the stem in its center the whole travel distance ,the force of the stem to return to its free position shall be measured. 开关的动作方向为垂直放置开关,在已有行程的推柄中心向上减小压力,推柄回到自由位
14、置时所测量到的力 45 gf min6.2.4.Stop Strength静止强度Placing the switch such that the direction of switch operation is vertical,a static load of 3 kgf shall be applied in the direction of stem operation for a period of 60 seconds. 开关的动作方向为垂直放置开关,在推柄动作方向施加3KG的静负荷,60秒时间There shall be no sign of damage mechanicall
15、y and electrically.无机械的和电气的损伤迹象6.2.5.Stem Strength推柄的强度Placing the switch such that the direction of switch operation is vertical, the maximum force to withstand a pull applied oppsite to the direction of stem operation shall be measured. 开关的动作方向为垂直放置开关,从推柄动作方向反方向施加拉力所测量到的最大承受力 3 kgfAPPDCHKDDSGDPART
16、 NO:工 程 部赵 高 杰05.11.10研 發 部吴 公 元05.11.10研 發 部周 成 艮05.11.10DOCUMENT NO:SPECTSZ.DOC3/10ZONESYMBDATEAPPDCHKDTACTING SWITCH SPECIFICATION6.3Environmental环境Item项目Test Condition测试条件Requirements要求6.3.1.Resistance to Low Temperatures耐低温Following the test set forth below the sample shall be left in normal te
17、mperature and humidity conditions for one hour before measurements are made:样品按下列条件进行耐低温试验,测试前在正常温度和湿度条件下放置1小时(1) Temperature: -302 温 度(2) Time: 96 hours 时 间(3) Water drops shall be removed. 擦除水珠Item 6.1Item 6. 2.1Item 6.2.26.3.2.Heat Resistance耐热Following the test set forth below the sample shall b
18、e left in normal temperature and humidity conditions for one hour before measurements are made: 样品按下列条件进行耐热试验,测试前在正常温度和湿度条件下放置1小时(1)Temperature: 802 温 度(2) Time: 96 hours 时 间Item 6.1Item 6. 2.1Item 6.2.26.3.3.Moisture Resistance耐潮湿Following the test set forth below the sample shall be left in normal
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 小龟直按 TVAU07 轻触 开关
限制150内