Kirin-EVT-LTE-Manual-test-Nonsignaling-part(4页).docx
《Kirin-EVT-LTE-Manual-test-Nonsignaling-part(4页).docx》由会员分享,可在线阅读,更多相关《Kirin-EVT-LTE-Manual-test-Nonsignaling-part(4页).docx(4页珍藏版)》请在得力文库 - 分享文档赚钱的网站上搜索。
1、-Kirin-EVT-LTE-Manual-test-Nonsignaling-part-第 4 页Kirin EVT LTE Manual test SOP-Nonsignaling Part Eva 2016/04/07Contents1. Station Setup diagram2. CMW500 FW3. Operation steps 3.1 Remote CMW5003.2 Set in CMW5003.3 Go to test mode3.4 Set in QRCT and get results1.Station Setup diagram1 Connect the MLB
2、with CMW 500 and PC as following.2. CMW500 FW1 List the CMW500 FW which we used in EVT, will Keep confirm with RF HW team, update if any.3. Operation steps 3.1 Remote CMW500 1 Change PCs IP address to ensure your computer and the CMW500 are in the same domain.2 Connect CMW500 as below and input the
3、password “instrument” , then click “OK” or press “Enter”.3.2 Set in CMW500Example: Port A LTE B1 CH 18300 1 Open CMW500, press “Ctrl + G” and choose and choose “Generator2 Click “Config ” and setup parameters as the picture below.3 Choose ARB file. Click “ARB” and “select ARB File”. Choose waveform
4、then click OK.4Click “ON/OFF” or press “Ctrl+ Enter” to turn on the Generator.5 Open CMW500, press “Ctrl + M” and then choose “TX Measurement1” under “LTE” and enable it.6Click “Config ” and setup parameters as the picture below.7 Click the button “Multi Evaluation OFF” and press “ Ctrl + Enter ” to
5、 enable Multi Evaluation”.3.3 Go to test mode1 Click the “ttermpro ” and set as Picture 1,then click Setup-Serial port- following picture2 Picture 1 Picture 22 Open DC power (Voltage=3.8V, Limit Current=1.5A) and DUT will go to Diags mode when you see “:-)”. Then type “bbonbypass” and enter.base -by
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- Kirin EVT LTE Manual test Nonsignaling part
链接地址:https://www.deliwenku.com/p-37111600.html
限制150内